From the Blog

Generac Generator Won't Start? Here's What to Check Before You Call

Generator won't start, showing a fault code, or shutting down? Learn the safe first steps Tulsa homeowners can take — and when to call for Generac generator repair.

The whole point of a standby generator is that it works when everything else doesn't. So when yours won't start, shuts down mid-outage, or lights up with a fault code, it's stressful — especially if a storm is rolling in. Here's how to approach the problem safely, and what information helps us fix it faster.

First: safety comes before troubleshooting

Before anything else:

  • If you smell gas, see smoke, or suspect carbon monoxide, move to safety and contact emergency services or your gas utility. Do not attempt a restart.
  • Never open energized electrical equipment or try to bypass the transfer switch.
  • Never service a running unit.

Everything below is about gathering information — not opening panels or turning wrenches.

The most common reasons a generator won't start

A no-start condition usually traces back to one of a few systems:

  • Battery — the single most common culprit. Batteries age, connections corrode, and a weak battery can't crank the engine. This is also why a generator can pass its weekly exercise for months and then fail under real load.
  • Fuel supply — a closed gas valve, an empty propane tank, or a supply issue will prevent starting or cause shutdowns.
  • Controller status — the unit may be in an alarm state, switched off, or showing a fault that locks out operation until it's addressed.
  • Engine concerns — oil level, overdue maintenance, or mechanical issues.

The key point: these causes look identical from the outside. Diagnosis beats guessing — replacing parts at random gets expensive fast.

If you see a fault code, write it down

The controller display is your best clue. Before you call:

  1. Record the exact fault message or code — word for word, including any numbers.
  2. Note when it appeared — during the weekly exercise, during an outage, or at startup.
  3. Don't repeatedly clear the alert or force restarts. A fault code is a starting point for diagnosis, not a confirmed cause — and clearing it repeatedly can mask the underlying problem or make things worse.

Information that speeds up your repair visit

When you call, having these details ready helps us understand the issue before we schedule:

  • Model and serial number from the unit's data plate
  • The exact fault message, if any
  • When it was last maintained and roughly how many hours it ran during the last outage
  • What happened — won't crank, cranks but won't start, starts then shuts down, or runs but doesn't power the home

That last distinction matters. A generator that runs but doesn't power the house points toward the transfer switch or electrical side — work our trusted licensed electrician partners handle.

Will the repair be covered by warranty?

It depends on your model, warranty period, the specific failure, and your registration and maintenance history. If you think the repair might qualify for Generac warranty coverage, have your purchase, registration, and service records ready — the applicable warranty terms determine eligibility, and maintenance records are often part of that review.

Get it diagnosed before the next storm

A generator with a known fault is a backup plan with a hole in it. American Home Pros provides Generac generator repair throughout Tulsa and Green Country as an authorized Generac dealer. Call (539) 500-1776 or request repair online. And if your unit is overdue for service, ask about generator maintenance while you're at it — most no-start calls we see could have been caught in a routine visit.

By Cody Dampf ·

Related reading

Services we provide